U1 Process Heater Module (PHM)

With a heating requirement below 1MM BTU/Hr, the Kenilworth Combustion U1 Process Heater Module is the perfect system for almost any application. It ships from our facility pre-assembled, function tested and ready to install. The U1 PHM comes in two specific configurations, one for lower gas pressure and one for higher gas pressure/low power consumption. Both come with everything you would expect from Kenilworth Combustion products including safety, reliability, and efficiency.

U1 HP Process Heater Module (PHM)
U1_HP
U1_HP

The U1 PHM is available in two different configurations, the HP (High Pressure) and LP (Low Pressure). These two systems have been specifically designed to work with any direct fired firetube with a demand below 1,000,000 BTU/hr. These systems are commonly used as tank heaters and as gas process heaters but given their adaptability the possibilities are limitless!

As with all Kenilworth Combustion systems, it comes with the patented Kenilworth Combustion burner, all controls are pre-assembled and fully function tested before arriving on site. All Kenilworth Combustion systems have a 100% guarantee that they are CSA B 149.3 compliant.

U1 LP Process Heater Module (PHM)
U1_LP
U1_HP PHM SPEC SHEET
U1_LP PHM SPEC SHEET
U1 PHM PID
U1 PHM
ELEC
U1 PHM
BOM

© 2019 Kenilworth Combustion

Box 3694, Vermilion, AB, T9X 2B7, info@kenilworth.ca